Fitness Equipment Coating Manual Electrostatic Powder Spray Line

Qingdao Jobon Science&Tech Development Co., Ltd. is one of the most reliable manufacturers and suppliers of Fitness Equipment Coating Manual Electrostatic Powder Spray Line in China. As we have world-leading production equipment and strong manufacturing capabilities, we warmly welcome you to buy premium Fitness Equipment Coating Manual Electrostatic Powder Spray Line for sale here from our factory. For price consultation, contact us.

 

Fitness equipment parts are a mixed bag: long welded tube frames, heavy weight plates, dumbbell heads, foot plates and covers.

Shapes and weights vary a lot, and model changes are frequent.

A manual conveyor line can fit this kind of work.

The conveyor carries parts from loading to the booth, into the curing oven, and to unloading.

The oven can keep working while spraying continues, so the line does not have to stop and wait.

Parts hang on the conveyor and can pass the booth at a steady speed, which helps keep the coating even.

Track joints have automatic alignment and locking, they do not need to be adjusted over and over again, and a fully loaded beam can run through the whole line smoothly.

 

The fitness equipment coating electrostatic powder spray line mainly has 4 parts: electrostatic spray guns, a powder booth, a curing oven, and the overhead conveyor system.

Manual equipment costs less comparing to the automatic spray line, but choose the spray gun carefully, if powder coverage is poor, the money saved on equipment goes back out in rework.

 

Maintenance:

Before spraying, check grounding at the part and the conveyor, and check the air compressor.

Clean the gun after every shift. Powder left inside will clog the gun and cause uneven output.

Check the venturi tube daily or every shift. When it wears, powder output drops or stops.

If the booth uses single-stage filter recovery, shake the filters regularly to recover powder.

Keep the curing oven clean. Dirt inside the oven can fall onto parts.

 

To design a fitness equipment coating line, we need to know:

1) Maximum part size and gross weight,

2) Target output per 8-hour shift based on the largest part,

3) Heat source (gas, electric or diesel),

4) Available length, width and height in the plant,

5) local industrial power supply.

 

Contact us to discuss more.

Hot Tags: Fitness Equipment Coating Manual Electrostatic Powder Spray Line, suppliers, manufacturers, price, for sale, Aluminum Coating Automatic Powder Coating System, Aluminum Profile Powder Coating Line, Automated powder coating line for steel, Automatic Traverse System Powder Coating Line, Cost effective small powder coating line, Metal Powder Coating Line